Generator Automatic Standby

Generac 10kw Generator to power only vaccine refrigerators Plot plan needed 9/28/26 10/9/26 - Rcv'd Per Email 1. Please see the attached spec sheet for the Generac 10kW generator we have been using at ProHealth sites. Page #5 of the spec sheet has the information on the transfer switch/panel as well. 2. We will be installing [2] dedicated circuits out of the transfer switch/panel to feed the [2] refrigerators and [1] freezer. New generator protected outlets will be snaked in and installed next to the existing outlets where the refrigerators/freezer are currently plugged into. [1] refrigerator draws 6.0 amps, [1] refrigerator draws 0.9 amps, & [1] freezer draws 1.0 amps. There is NO medical wiring in this suite. From what I saw; all wiring was in romex because of sheetrock ceilings. 3. I am not aware of any CDC requirements, Gina, are you aware of any requirements??? Your application for a Building Permit has been reviewed for compliance with the 2022 State of Connecticut Building Code. The permit for the proposed work is approved. All work is subjected to field inspections. Comments below are to be reviewed and followed. 1.Any and all electrical work is to follow all applicable sections of the 2022 State of Connecticut Building and 2020 NFPA 70 National Electrical Code and any applicable sections of NFPA 99 2.Owners responsibility to comply with any outside agencies such as the CDC. New location and screen plan needed from applicants due to business zone. 10/13/26 JH