ADDITION

remove the existing furnace and install a central air AC/furnace Remove and dispose of the existing furnace and air conditioning equipment, if applicable. Install one (1) new 4-ton horizontal furnace and matching evaporator coil in the basement. Set and secure the furnace on the required supports/hanging system and ensure the unit is level. Connect the furnace and evaporator coil to the existing ductwork, making minor duct modifications as needed for a proper fit and airflow. Install a new condensate drain with the required trap and proper pitch to an approved drain location. Install the outdoor condensing unit on a precast concrete equipment pad located on the side of the house and secure the unit in place. Install insulated refrigerant line sets between the indoor and outdoor units, including the required protective line-hide or insulation where applicable. Install the electrical disconnect, whip, low-voltage thermostat wiring, and complete all required electrical connections. Pressure test the refrigerant piping, evacuate the system to the manufacturer's specifications, and charge the system with refrigerant as required. Install and program the new thermostat and verify proper communication between the indoor and outdoor equipment. Start up the system and perform operational testing, including airflow, temperature split, refrigerant pressures, electrical readings, and safety controls. Verify proper condensate drainage, heating and cooling operation, and leave the work area clean upon completion. All Natural gas or propane connections are done by the plumber.